There are currently two ways to reset a Cisco router or switch to factory default.

Reference: http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_tech_note09186a00802017a1.shtml

Method 1

This method uses the config-register 0x2102 command in global configuration mode.

Method 2

This method uses the config-register 0x2142 command in global configuration mode.

Should you have any questions, comments or suggestions, please don’t hesitate to comment below. If you like what you have read, please share it on your favourite social media medium.

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.